The mechanisms of glass transitions and the behavior of small solute molecules in a glassy matrix are some of the most important topics of modern thermodynamics. Water plays an important role in the physical and chemical stability of lyophilized biologics formulations, in which glassy carbohydrates act as cryoprotectants and stabilizers. In this study, sorption calorimetry was used for simultaneous measurements of water activity and the enthalpy of water sorption by amorphous sucrose, trehalose and maltodextrins. Moreover, the heat capacity of these carbohydrates in mixtures with water was measured by DSC in a broad range of water contents. The hydration enthalpies of glassy sucrose, trehalose and maltodextrins are exothermic, and the enthalpy change of water-induced isothermal glass transitions is higher for small molecules. The partial molar enthalpy of mixing of water in slow experiments is about -18 kJ mol-1, but less exothermic in the case of small molecules at fast hydration scan rates. By measuring the heat capacities of disaccharides and maltodextrins as a function of water content, we separated the contributions of carbohydrates and water to the total heat capacities of the mixtures. The combination of these data allowed testing of thermodynamic models describing the hydration-induced glass transitions. The heat capacity changes calculated by the fitting of the hydration enthalpy data for disaccharides are in good agreement with the heat capacity data obtained by DSC, while for maltodextrins, the effect of sub-Tg transitions should be taken into account. Combining the data obtained by different techniques, we found a distinct difference in the behavior of water in glassy polymers compared to that in glassy disaccharides. By understanding the behavior of water in glassy carbohydrates, these results can be used to improve the design of freeze-dried formulations of proteins and probiotics.

The purpose of this study is to critically analyze different methods of calculation of activation energy of relaxation in sucrose-water system from differential scanning calorimetry data. We consider the use of different thermal cycles for calculations together with Moynihan and Kissinger equations. We study the effect of two methods of glass transition temperature determination (half-step and inflection point) on the activation energy values. Along with experimental DSC data, we use the data simulated using Tool-Narayanaswamy-Moynihan model to validate the use of cooling and heating curves and to check the reproducibility of the activation energy calculations. The obtained results show that the thermal cycle with equal cooling and heating rates provides the most reliable data set and the glass transition temperature definition using inflection point rather than half step can be recommended for calculations. Moreover, due to technical reasons, heating rather than cooling scans provide the most reliable results of activation energy calculations. Furthermore, a simple method based on the width of the glass transition region shows reasonable results for single scan experiments. The activation energies of the glass transition in sucrose-water system with different water contents and different thermal histories were studied. Since it is impossible to apply traditional methods based on Moynihan equation for the activation energy evaluation for freeze-dried samples, we propose using another method based on the properties of the recovery peak. Combining the results obtained by different methods, we present a dependence of activation energy in sucrose-water system on water content. The results show that water decreases the activation energy of relaxation process in sucrose matrix.

The ice crystallization and melting in systems where the equilibrium state is difficult to reach is one of the growing areas in pharmaceutical freeze-drying research. The quality of the final freeze-dried product depends on the parameters of the cooling step, which affect the ice nucleation and growth. In this paper, we present a DSC study of ice crystallization and melting in a sucrose-water system. Using two different types of thermal cycles, we examine the influence of cooling and heating rates on the thermal behavior of sucrose-water solutions with water contents between 50 and 100 wt%.

The DSC results show that low cooling rates provide crystallization at higher temperatures and lead to lower amount of nonfreezing water. Consequently, the glass transition and ice melting properties observed upon heating depend on the cooling conditions in the preceding step. Based on the experimental results, we investigate the reasons for the existence of the two steps on DSC heating curves in sucrose-water systems: the glass transition step and the onset of ice melting. We show that diffusion of water can be the limiting factor for ice growth and melting in the sucrose-water system when the amorphous phase is in a liquid state. In particular, when the diffusion coefficient drops below 10−14 m2/sec, the ice crystals growth or melting becomes strongly suppressed even above the glass transition temperature. Understanding the diffusion limitations in the sucrose-water system can be used for the optimization of the freeze-drying protocols for proteins and probiotics.

The freeze-drying of proteins, along with excipients, offers a solution for increasing the shelf-life of protein pharmaceuticals. Using differential scanning calorimetry, thermogravimetric analysis, sorption calorimetry, and synchrotron small-angle X-ray scattering (SAXS), we have characterized the properties at low (re)hydration levels of the protein lysozyme, which was freeze-dried together with the excipient sucrose. We observe that the residual moisture content in these samples increases with the addition of lysozyme. This results from an increase in equilibrium water content with lysozyme concentration at constant water activity. Furthermore, we also observed an increase in the glass transition temperature (Tg) of the mixtures with increasing lysozyme concentration. Analysis of the heat capacity step of the mixtures indicates that lysozyme does not participate in the glass transition of the sucrose matrix; as a result, the observed increase in the Tg of the mixtures is the consequence of the confinement of the amorphous sucrose domains in the interstitial space between the lysozyme molecules. Sorption calorimetry experiments demonstrate that the hydration behavior of this formulation is similar to that of the pure amorphous sucrose, while the presence of lysozyme only shifts the sucrose transitions. SAXS analysis of amorphous lysozyme–sucrose mixtures and unfolding of lysozyme in this environment show that prior to unfolding, the size and shape of lysozyme in a solid sucrose matrix are consistent with its native state in an aqueous solution. The results obtained from our study will provide a better understanding of the low hydration behavior of protein–excipient mixtures and support the improved formulation of biologics.